Type de bien: Sloop
Année de construction: 2000
Matériau de la coque: Aluminum
Longueur: 30.48m / feet
Largeur: 7.19 / 23.59 feet
Tirant d'eau max: 3.63 / 11.91 feet
[Gross Tonnage]: 111
Vitesse de croisière: 9 knots
Vitesse max: 11 knots
Invités: 8
Cabines: 3
Équipage: 4
Moteurs: 1
Pavillon: Marshall Island
Region: Italy, Genoa


EUR 2,900,000

Demandez des renseignements

Nom *
Email *
Tél. *
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.

owner cabin


• Full beam with two double beds either side

• Luxurious en-suite bathroom, with stall shower

Guest Cabins

• Two double twin cabins port and starboard forward

• Port forward cabin is equipped with an en-suite bathroom


Crew Area


• Two bunk cabins port and starboard

• Crew mess with U Shaped sofa, all electric controls

• Crew bathroom that doubles as an en-suite for the port forward guest cabin



• Two helm stations equipped with all sail controls

• Fantastic 360º views over and along the deckhouse

• Large table with U shaped sofa in blue leather port side

• Navigation and transmission equipment starboard side

• Steps into the upper deck salon and lower deck salon




Mast and rig pulled out of boat and all rigging removed for inspection

• All running rigging replaced

• Cabling, lights, and electronics checked, serviced or replaced

Hydraulic furles serviced and rebuilt by Rondal

Hydraulic halyard rams serviced

Hydraulic aft stay tensioners serviced

Hydraulic boom van serviced

Mast & boom re-installed and tuned

New Furuno radar and navigators installed

New PC screens

New cockpit resolution waterproof monitor

New B&G processor and triton

New Gyro-track compass installed

• All batteries serviced and or replaced




New electric motor

Variable pitch gear box taken out, dismantled and serviced. All new

Marine gearbox “Twin Disc” taken out and rebuild, new seals &





Under water Hull sand blasted, inspected

Propeller, shaft, variable pitch system and gear box works:

Variable pitch propeller Teignbridgedismantled and serviced

Propeller shaft pulled out, taken to machine shop. Installed in lathe,

 checked for wear & torsion, cleaned. Was in perfect condition.

Propeller shaft bearings serviced. oil and water seals, both engine

 room side and water side, all replaced.

Propeller shaft oil bath oil replaced

Propeller shaft aft “cutlass bearingreplaced

Main engine rubber support blocks replaced (all 2 )

Propeller shaft & main engine re-aligned. Boat sea trials showed

 perfect alignment.

Rudder pulled out full service

Rudder lower and upper bearings serviced

Steering system & steering quadrant serviced

• New bearing Laghersmith

Zink anodes new

Brand new sails

• New tender Geniuss 320

Aft Deck

• Offers access to the lazarette

• Hydraulic swim platform